HIGH STANDARD VICTOR REPLACEMENT SCOPE BASE
The Scope Base was designed to replace the factory rib installed on the High Standard Victor pistol. Installing the Scope Base on the pistol instead of the factory rib will allow an optical sight to be mounted on the pistol. The hole locations on the replacement scope base is the same as the original factory holes. This will eliminate having to drill and tap any additional holes in the barrel to mount an optical sight. The holes are counterbored to accept socket head cap screws and eliminate using the factory flat head screws with the small hex hole. Quite often when Loctite is used on the factory screws the small hex hole will be rounded when trying to remove the screws. An angled ejection port is milled into the bottom of the scope base to help eliminate ejection problems. Mounting screws and a hex wrench are included with the rib.
PT-60 High Standard Victor 4-1/2 Inch Barrel Scope Base ........ $40.00
PT-61 High Standard Victor 5-1/2 Inch Barrel Scope Base ........ $40.00